Hitachi 55HDS52 Owners Guide - Page 46

Channel Manager Channel Manager Select CHANNEL MANAGER to set your Antenna options, run Auto Channel Scan, Check Signal Meter and Set Channel List. 1. Press CURSOR PAD ̆, ̄ or CHANNEL WHEEL to highlight function 2. Press the SELECT button or CURSOR PAD ̈ to select. Video Audio Channel Manager Locks Timers Setup Power Swivel Move SEL Select Channel Manager Signal Meter or Auto Channel Scan Channel List Move SEL Select On-Screen Display Signal Meter Select SIGNAL METER when using an indoor or outdoor antenna. This feature will show the signal strength and peak values of the Antenna signal to help you adjust your antenna to optimize signal reception. Use the CURSOR PADS and the SELECT button to highlight and select CLOSE to exit. NOTE: The Signal Meter will not be available (grayed out) when watching analog channels. or Channel Manager Signal Meter Auto Channel Scan Channel List Move SEL Select Channel Manager Signal Meter Channel 3- Strength 1 Peak 1 Close Move SEL Return Auto Channel Scan This feature will automatically store active Analog and Digital channels in Auto Channel Scan memory. 1. Use the CURSOR PAD ̆ or ̄ or CHANNEL WHEEL to highlight CABLE or AIR. 2. Press the CURSOR PAD ̇ or ̈ to highlight the START or CLEAR option. 3. Press the SELECT button to start AUTO CHANNEL SCAN. or NOTE: 1. 2. When a CableCARD is installed, Auto Channel Scan will not be available since channels will be fixed based on what was agreed upon by you and your cable operator. If certain channels are poor or not possible in cable(1) mode, set cable source to cable(2) by using the CURSOR buttons ̇ or ̈. 46 Channel Manager Signal Meter Auto Channel Scan Channel List Move SEL Select Channel Manager Auto Channel Scan Cable Auto Channel Scan Cable Source Air Auto Channel Scan Move SEL Return Start Reset Cable(1) Start Reset