Hitachi FXTRIO-77 User Guide - Page 25
Be sure to use two or more people for this work.
View all Hitachi FXTRIO-77 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
StarBoard FX-TRIO Series [2] Install the board Introduction CAUTION Be sure to use two or more people for this work. Failure to comply may cause the board to fall, resulting in personal injury, or may cause damage to this product due to shock of impact. Tighten the screws securely. Failure to comply may cause the board to fall, resulting in personal injury, or may cause damage to this product due to shock of impact from the board falling. Install the board on the stand assembled in step [1]. Install the board according to the following procedure. Note that this work should be performed by two or more people. The numbers in the diagram correspond to the numbers in the parts list on page 1-3 of this User's Guide. Board (4)(5) (6) (10) (a) Decide the level (out of six) at which the board will be installed, and attach the board receiving brackets (4) and (5) to the square holes of the stays on the back of the board. (b) Verify that the square holes are attached securely to the board receiving brackets on both sides. (c) Fix the board fixing brackets (6) temporarily on the stand vertical supports (1) using the pan head screws (9). (d) Tighten the triangular knob screw (10) to fasten the board to the board fixing bracket (6) on both sides. (e) Tighten the pan head screws that were fixed temporarily in (c). 1-11 English