Hitachi LE46S704 Owners Guide - Page 12

Quick Setup Guide Perform the following steps to quickly setup your new Hitachi LCD Television Set. 1. ANTENNA CONNECTION Unless your LCD Television is connected to a cable TV system or to a centralized antenna system, a good outdoor color TV antenna is recommended for best performance. However, if you are located in an exceptionally good signal area that is free from interference and multiple image ghosts, an indoor antenna may be sufficient. VHF (75-Ohm) antenna/CATV (Cable TV) When using a 75-Ohm coaxial cable system, connect the CATV coaxial cable to the AIR/CABLE (75-Ohm) terminal. Or if you have an antenna, connect the coaxial cable to the same AIR/CABLE terminal. Rear Panel Jack Air/Cable To outdoor Antenna or Cable TV (CATV) System To AIR/CABLE Terminal 2. CONNECT YOUR NEW HITACHI LCD TV TO THE POWER SOURCE a). Secure it with the Wire Clamp (see page 7) . c). The Indicating Lamp will light red (Standby mode) and then Wire Clamp light blue (picture is shown). Indicating Lamp b). Connect the power cord to the AC outlet. 3. POWER ON/OFF YOUR NEW HITACHI LCD TV Press the POWER button on the remote control or the POWER button on the Front Control Panel to power on/off the LCD TV. NOTE If the Indicating lamp is off, the POWER button on the remote control will not operate. Please make sure that the power cord is plugged to the AC outlet. or For Stand-By Power OFF CLU-49101S 4. FOLLOW THE TV SETUP WIZARD INSTRUCTIONS ON NEXT PAGE 12