Hitachi LE46S704 Owners Guide - Page 22

How To Use The Remote Control To Control Your AV Device OPERATING THE PRECODED FUNCTIONS FOR YOUR AV DEVICE. The new remote control is designed to operate different types of VCRs, cable boxes, set top boxes, satellite receivers, DVD players, and other audio/video device. You must first program the remote control to match the remote control system of your AV device (refer to pages 26~27 for a preprogrammed code number). AV DEVICE CONTROL SETUP PROCEDURE 111 Turn on your AV Device. Power Button 1 Device Buttons 2 222 Select the desired mode: DVD, PVR/VCR, SAT/CBL or AVR by pressing the corresponding button. 333 Hold down the device button (DVD, PVR/VCR, SAT/CBL or AVR) on the remote control and enter the four digit preset code that matches your device as shown on pages 26~27. 444 Release the device button. Numeric Buttons 3 555 If done correctly, the device LED indicator will blink 3 times to confirm proper setup. 666 The remote control will now control the desired device. SETUP EXAMPLE (Hitachi Cable Box with precode 0003) 111 Turn ON your cable box. 222 Select cable mode by using your SAT/CBL button to position the LED indicator on SAT/CBL. 333 Hold down the SAT/CBL button on the remote control and press the numbers 0, 0, 0 and 3. 444 Release the SAT/CBL button. 555 The indicator light will flash 3 times if the code was accepted. 666 Aim the remote control at the cable box and press the POWER button. The remote control will turn off your cable box when the correct four digit preset code is entered. When this occurs, the remote control is programmed for your cable box. If the cable box does not turn off, try a different four digit preset code. 777 The remote control will now control your cable box. Repeat the same procedure for your set top box or satellite receiver (select SAT/CBL), your DVD (select DVD), your VCR/ PVR(select VCR/PVR), or your AVR (select AVR). CLU-49101S NOTES • • • 22 If your AV device cannot be operated after performing the above procedures, your AV device code has not been preprogrammed into the remote control. In the unlikely event that your AV device cannot be operated after performing the above procedures, please consult your AV device owners guide. The remote control will remember the codes you have programmed even after the batteries are removed from the remote control. To reset all programmed codes to factory default place remote control in TV mode, then press and hold TV mode button and enter "9", "8", "1" in sequence.