Hitachi NR90AD Instruction Manual - Page 14

English 1 Upward position Switching Device Trigger Switching Device 1 Downward position Previously pull the trigger 4 3 2 4 Push Lever (2) Continuous operation (Push lever fire) Using CONTACT ACTUATION MECHANISM WARNING ⅷ To avoid double firing or accidental firing due to recoil. 1) Do not press the nailer against the wood with excessive force. 2) Separate the nailer from the wood as it recoils after nailing. 1 Set the switching device to the downward position (to set to CONTACT ACTUATION MECHANISM). (Set the switching device to the downward position completely as shown in the diagram. Otherwise, it will not operate properly.) 2 Pull the trigger with the Nailer off the workpiece. 3 Depress the push lever against the workpiece to drive a nail. 4 Move the Nailer along the workpiece with a bouncing motion. Each depression of the push lever will drive a nail. As soon as the desired number of nails have been driven, remove finger from the trigger. Push Lever WARNING ⅷ Keep your finger off the trigger except during fastening operation, because serious injury could result if the push lever accidentally contacts you or others in work area. ⅷ Keep hands and body away from the discharge area. This Hitachi nailer may bounce from the recoil of driving a fastener and unwanted subsequent fastener may be driven, possibly causing injury. ⅷ Some types of loaded nails can spark out of the muzzle during a nail driving operation. Exericise caution! NOTE: ⅷ If all warnings and instructions are followed, safe operation is possible with all two systems: SINGLE ACTUATION MECHANISM and CONTACT ACTUATION MECHANISM. ⅷ Always handle nails and package carefully. If nails are dropped, collating plastic may be broken. ⅷ After nailing: 1) disconnect air hose from the Nailer; 2) remove all nails from the Nailer; 3) supply 5 - 10 drops of Hitachi pneumatic tool lubricant into the air plug on the Nailer; and 4) open the petcock on the air compressor tank to drain any moisture. - 14 -