Hitachi NT65A3 Instruction Manual - Page 18
A Full Sequential Actuation Mechanism Kit Sequential Trip Mechanism Kit
UPC - 717709007895
View all Hitachi NT65A3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
English ● Choice of triggering method is important. Please read and understand "METHODS OF OPERATION" found below. ● Before starting work, check the nailing operation switching device. This Hitachi nailer includes a nailing operation switching device. Before starting work, make sure that the switching device is properly set. If the switching device is not set properly, the nailer will not operate correctly. ● Never place your hands or feet closer than 8 inches (200 mm) from firing head when using. ● Do not drive nails on top of other nails or with Nailer at too steep of an angle; nails can ricochet and hurt someone. ● Do not drive nails into thin boards or near corners and edges of workpiece. Nails can be driven through or away from workpiece and hit someone. ● Never drive nails from both sides of a wall at the same time. Nails can be driven into and through the wall and hit a person on the opposite side. ● Never use Nailer which is defective or operating abnormally. ● Do not use Nailer as hammer. ● Disconnect air hose from Nailer when: 1) attaching or removing nose cap; 2) it is not in use; 3) leaving work area; 4) moving it to another location; and 5) handing it to another person. This Hitachi nailer is equipped with a nailer operation switching device. Use SINGLE ACTUATION MECHANISM or CONTACT ACTUATION MECHANISM in accordance with the work to be performed. A FULL SEQUENTIAL ACTUATION MECHANISM KIT (SEQUENTIAL TRIP MECHANISM KIT) is also available as an option. Part no. 884178. Explanation of the various nailing operations ⅜ SINGLE ACTUATION MECHANISM (SINGLE SEQUENTIAL ACTUATION MECHANISM): First, press the push lever against the wood; next, pull the trigger to drive the nail. First, pull the trigger; next, press the push lever against the wood to drive the nail. After nailing once, nailing will not be possible again until the trigger is released and pressed again. ⅜ CONTACT ACTUATION MECHANISM: First, press the push lever against the wood; next, pull the trigger to drive the nail. First, pull the trigger; next, press the push lever against the wood to drive the nail. If the trigger is held back, a nail will be driven each time the push lever is pressed against the wood. ⅜ FULL SEQUENTIAL ACTUATION MECHANISM: First, press the push lever against the wood; next, pull the trigger to drive the nail. Follow the same sequence to continue driving nails. 18