Hitachi NV45AE Instruction Manual - Page 12
Adjusting Air Pressure, Warning, Loading Nails
UPC - 717709012868
View all Hitachi NV45AE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
English (2) Adjust the air pressure to 70 psi (4.9 bar 5 kgf/cm2). Connect the air hose. Do not load any nails in the Nailer. Ⅺ THE NAILER MUST NOT LEAK AIR. Hold the Nailer downward and pull the trigger. Ⅺ THE NAILER MUST NOT OPERATE. Pull trigger (3) With finger off the trigger, depress the push lever against the workpiece. Ⅺ THE NAILER MUST NOT OPERATE. Depress push lever ADJUSTING AIR PRESSURE WARNING ⅷ Do not exceed 120 psi (8.3 bar 8.5 kgf/cm2). Adjust the air pressure at recommended operating pressure 70 - 120 psi (4.9 - 8.3 bar 5 - 8.5 kgf/cm2) according to the length of nails and the hardness of workpiece. The correct air pressure is the lowest pressure which will do the job. Using the Nailer at a higher than required air pressure unnecessarily over stresses the Nailer. LOADING NAILS WARNING ⅷ When loading nails into Nailer, 1) do not pull trigger; 2) do not depress push lever; and 3) keep Nailer pointed downward. (1) Grip the nail guide and knob with your fingers. Press the knob down and swing the nail guide open. Then open the magazine cover. Knob Do not pull trigger (4) Without touching the trigger, depress the push lever against the workpiece. Pull the trigger. Ⅺ THE NAILER MUST OPERATE (5) With the Nailer off the workpiece, pull the trigger. Depress the push lever against the workpiece. Ⅺ THE NAILER MUST OPERATE. (6) If no abnormal operation is observed, you may load nails in the Nailer. Drive nails into the workpiece that is the same type to be used in the actual application. Ⅺ THE NAILER MUST OPERATE PROPERLY. Nail guide Magazine cover (2) Adjust the position of the nail holder according to the nail length. The nail will not feed smoothly if the nail holder is not correctly adjusted. 1 Turn the nail holder about 90 degrees counterclockwise. 2 Move the nail holder up and down to align the plate of the nail holder with a mark on the magazine in accordance with the length of the nails being used. 3 Turn the nail holder 90 degrees clockwise until you hear "click". - 12 -