Hitachi NV45AE Instruction Manual - Page 19
Most minor problems can be resolved quickly and easily using the table below.
UPC - 717709012868
View all Hitachi NV45AE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
English Maintenance chart ACTION Drain air line filter daily. Keep lubricator filled. Clean filter element - then blow air through filter in direction opposite to normal flow. Clean magazine and feeder mechanism. Keep push lever working properly. Lubricate the Nailer after nailing. Drain air compressor. WHY Prevent accumulation of moisture and dirt. Keep the Nailer lubricated. Prevent clogging of filter with dirt. Prevent a jam. Promote operator safety and efficient Nailer operation. Extend the Nailer life. Keep the Nailer operated properly. HOW Open manual petcock. Fill with Hitachi pneumatic tool lubricant. Follow manufacturer's instructions. Blow clean daily. Blow clean daily. Supply 5 - 10 drops of lubricant into the Nailer. Open petcock on air compressor tank. Operator troubleshooting Most minor problems can be resolved quickly and easily using the table below. If problems persist, contact a Hitachi authorized service center for assistance. PROBLEM Nailer operates, but no nail is driven. Weak drive. Slow to cycle. Drives too deep. Skipping nails. Intermittent feed. Nails jam. Driven nail is bent. Drives properly during normal operation, but does not drive fully at faster nailing speeds. CHECK METHOD Open nail guide. Check for a jam. Check function of feeder per page 17. Check for proper nails. Check air pressure. Check position of adjuster per page 16. --- Driver blade worn? Piston O-ring worn or damaged? Check air pressure. Check position of adjuster per page 16. Check for proper nails. Check function of nail feeder per page 17. --- Check position of nail holder in magazine per page 12 or 13. Piston O-ring cut or heavily worn? Check for proper nails. Driver blade worn? CORRECTION Clear a jam per page 17. Clean and lubricate. Use only recommended nails. Increase air pressure. (Do not exceed 120 psi (8.3 bar 8.5 kgf/cm2)) Readjust. Use Hitachi pneumatic tool lubricant. Contact Hitachi for replacement. Reduce air pressure. (Adjust 70 - 120 psi (4.9 - 8.3 bar 5 - 8.5 kgf/cm2)) Readjust. Use only recommended nails. Clean and lubricate. Use Hitachi pneumatic tool lubricant. Adjust nail holder to proper position. Contact Hitachi for replacement. Use only recommended nails. Contact Hitachi for replacement. Check inside diameter of air hose. Use larger air hose. - 19 -