HoMedics AF-75 Downloadable Instruction Book - Page 4

Operating Instructions, Control Panel - filter

Page 4 highlights

NOTE: This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of shock, this plug is intended to fit only one way in a polarized outlet. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT attempt to defeat this safety feature. To do so could result in an electric shock hazard. Control Panel Power ON/OFF Control Clean/Reset Filter Indicator Button CLEAN FILTER 1 2 3 Fan Speed Selection (Low/Medium/High) NOTE: The Clean/Reset Filter Indicator MUST be pressed to reset the indicator after you have cleaned and replaced the filter. 6 Operating Instructions Turning the Unit On • Take the air cleaner out of the box and remove the clear protective plastic bag. • Place the air cleaner on a firm level surface. • Before turning the air cleaner ON, you need to check that the filters are firmly in place and did not become loose during shipping. 1. To check filter, open the front grill by pulling on the tabs on either side of the top of the grill plate. Fig. 1 Fig. 1 2. Open the plate outward until the tabs at the bottom of the grill plate easily slide away from the unit. Fig. 2 Fig. 2 3. The HEPA filter will be resting inside the unit. Make sure that the filter is firmly seated inside of the unit. Fig. 3 Fig. 3 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14

6
7
Operating Instructions
Turning the Unit On
• Take the air cleaner out of the box and remove the clear protective plastic bag.
• Place the air cleaner on a firm level surface.
• Before turning the air cleaner ON, you need to check that the filters are firmly in
place and did not become loose during shipping.
NOTE: This appliance has a polarized plug (one blade is wider than
the other). To reduce the risk of shock, this plug is intended to fit only
one way in a polarized outlet. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician.
DO NOT attempt to defeat this safety feature. To do so could result in
an electric shock hazard.
Control Panel
NOTE: The Clean/Reset Filter Indicator MUST be pressed to reset the
indicator after you have cleaned and replaced the filter.
Fig. 1
Fig. 2
Fig. 3
1. To check filter, open the front grill by
pulling on the tabs on either side of
the top of the grill plate. Fig. 1
2. Open the plate outward until the tabs
at the bottom of the grill plate easily
slide away from the unit. Fig. 2
3. The HEPA filter will be resting
inside the unit. Make sure that the filter
is firmly seated inside of the unit. Fig. 3
CLEAN FILTER
1
2
3
Clean/Reset Filter Indicator Button
Fan Speed Selection (Low/Medium/High)
Power ON/OFF Control