HoMedics BPA-250 User Manual - Page 16

POTENTIAL FOR RADIO/TELEVISION INTERFERENCE For USA only: This product has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. The product generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the product on and off, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the product and the receiver. • Connect the product into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. For Canada only: This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled "Digital Apparatus", ICES-003 of the Canadian Department of Communications. Cet appareil numérique respecte les limites de bruits radioeléctriques applicables aux appareils numériques de Classe B prescrites dans la norme sur le matériel brouilleur: "Appareils Numériques", ICES-003 édictée par le ministre des communications. 29 TROUBLESHOOTING If any abnormality arises during use, please check the following points SYMPTOMS POSSIBLE CAUSES CORRECTION Unit does not turn on Batteries have Replace them with when the run down. four new AA START/STOP alkaline batteries. button is pushed. Battery polarities Re-insert the batteries have been positioned in the correct posi- incorrectly. tions. EE measurement Cuff has been placed Wrap the cuff proper- error symbol shown incorrectly. ly so that it is posi- on display or the tioned correctly. blood pressure value Did you talk or move Measure again. Keep is displayed exces- during measurement? arm steady during sively low (or high). Shaking of the arm with the cuff on. measurement. E1 error symbol shown on display E2 error symbol shown on display E3 error symbol shown on display Air circuit abnormality. Check cuff connection. Cuff tube may not be Measure again. plugged into monitor correctly. Inflation pressure Switch the unit off, exceeding 300 mmHg. then measure again. Data error. Remove and reload the batteries. CA Appears on display Recalibration alert. Refer to page 26 for more information. Note: If the unit still does not work, contact HoMedics Consumer Relations. Under no circumstance should you disassemble or attempt to repair the unit by yourself. Contact information for HoMedics Consumer Relations Department can be found on the warranty page. 30