HoMedics BPA-250 User Manual - Page 7

INSTALLING BATTERIES Note: It is recommended that you use batteries only for travelling or when it is not possible to use the AC adapter. 1. Extend the tray so that the battery cover is fully exposed. 2. Press down on latch and lift the battery cover towards you to open the battery compartment. 3. Install or replace 4 "AA" sized batteries in the battery compartment according to the indications inside the compartment. 4. Replace the battery cover by clicking in the bottom hooks first, then push in the top end of the battery door. Battery Cover Slide-Out Tray Replace the batteries if: 1. The weak battery symbol appears on the display. 2. Nothing appears on the display when the power is switched on. 11 As the supplied batteries are for test only, they may be discharged earlier than batteries you buy in stores. Replace the batteries in pairs. Remove batteries when unit is not in use for extended periods of time. Note: Batteries are hazardous waste. Do not dispose of them together with the household garbage. USING THE AC ADAPTER Note: • Please unload the batteries when operating with the AC adapter for an extended period of time. Leaving the batteries in the compartment for a long time may cause leakage, which may lead to damage of the unit. • No batteries are needed when operating with the AC adapter. 1. Connect the AC adapter with the AC adapter jack in the back of the unit as shown below. 2. Please use only the AC adapter included with this monitor. AC Adapter Input: 120V 60Hz Output: 12V DC 500mA Connect AC adapter here 12