HoMedics DWS-130 User Manual - Page 3

DWS-130SP-ENG.qxd 10/12/04 11:36 AM Page 5 TEMPERATURE TREND INDICATOR: In the upper left hand corner of the home receiver LCD display, you will see one of 3 icons; will indicate Rising Temperature readings if it changes more than 1 degree in an hour will indicate Steady Temperature readings will indicate Falling Temperatures if it is more than 1 degree in an hour. TEMPERATURE ALERT Press "ALERT" to turn temperature alert on and off. 1. Hold "ALERT" button located on back of home receiver for 3 seconds to enter the alert setting mode. The indoor icon will flash. 2. Press " +, - " to select the between indoor temperature or outdoor temperature to be alerted to. Press "ALERT" to confirm your selection. The Upper pointer and the value on the LCD display will flash. Enter the desired upper limit with the " +, - " buttons, press "ALERT" to confirm your selection and then go to the lower limit setting. 3. The Lower pointer and value will flash. Enter the desired lower limit with " +, - " buttons. Press "ALERT" to confirm and exit. 4. You may enter an alert setting for the indoor temperature and remote sensor temperature. 5. When the temperature hits the limit of your preset levels, the Upper/Lower pointers and the temperature of the respective channel (indoor or remote sensor) will flash and produce an audible alarm. Press any button on the home receiver to acknowledge and stop the alarm. 6. To turn alert off, press "ALERT" button. The " " icons should not be shown. 4 LOW BATTERY INDICATION Low battery indication is available for the home receiver and the remote sensor. "LO" will be displayed on the remote sensor and a battery life " " icon will be shown on the home receiver. Replace the batteries as necessary and follow the setup procedure as mentioned earlier in the "GETTING STARTED" section. MOUNTING INSTRUCTIONS Table Top For the home receiver and the remote sensor, simply pull out the integrated stand from the bottom. Wall Mount For remote sensor and home receiver - Set a screw into the desired hanging location and mount. MAINTENANCE AND CARE INSTRUCTIONS • Extreme temperatures, shock or areas of unusual vibration should be avoided to prevent damage to the units. • Clean the units using only a soft, damp cloth to wipe. Do not use solvents, abrasives, detergents or other strong cleaning agents. After cleaning, wipe surfaces with a dry cloth. • Do not submerge units in water or other liquids. • Do not subject the units to extremely severe temperatures - DO NOT PLACE UNITS INTO OVENS, FREEZERS or MICROWAVE OVENS. 5