HoMedics DWS-320 User Manual - Page 3

DWS-320-IB_ENG\SP 10/12/04 11:38 AM Page 5 SETTING ALARM TIME 1. Hold the "ALARM " button for 3 seconds. 2. To select either first alarm (A1) or second alarm (A2) - Press " + , - " on back to toggle between selections. Press "ALARM " to confirm your selection. 3. Set alarm time - Press " + , - " on the back of the unit to enter the desired Hr/ Min values. Press "ALARM " to confirm. 4. To view alarm time - Press "ALARM " button once. Alarm time will display for 5 seconds and then resume to normal clock thereafter. 5. To select between alarm 1, alarm 2 or alarm off - Press " + " button on the back of the unit. For Daily Alarm - The appropriate " " icon will appear in the upper left corner of the time display. =Alarm 1 =Alarm 2 =Alarms 1& 2 are activated. No Alarm - The " " icons will not be shown. 6. The home receiver will provide either a daily alarm, which last for 2 minutes or a snooze mode where the alarm will repeat every 10 minutes until manually cleared (see SNOOZE/LIGHT section below.) 7. To turn alarm off - Simply press any button on the back of the unit. SNOOZE/ LIGHT 1. Press the SNOOZE/LIGHT button for an extended backlight. 2. In snooze alarm mode, press this button to trigger a repetitive snooze alarm. TEMPERATURE TREND INDICATOR: In the bottom right hand corner of the home receiver LCD display, you will see one of 3 icons; will indicate Rising Temperature readings if it changes more than 1 degree in an hour will indicate Steady Temperature readings will indicate Falling Temperatures if it is more than 1 degree in an hour. LOW BATTERY INDICATION Low battery indication is available for the home receiver and the remote sensor. A battery life " " icon will be shown on the home receiver or remote sensor. Replace the batteries as necessary and follow the setup procedure as mentioned earlier in the "GETTING STARTED" section. 4 MOUNTING INSTRUCTIONS Table Top For the home receiver, snap the two legs out from the back of the unit and fold out. For the remote sensor, simply pull out the integrated stand from the bottom. Wall Mount For the remote sensor and home receiver - Set a screw into the desired hanging location and mount. MAINTENANCE AND CARE INSTRUCTIONS • Extreme temperatures, shock or areas of unusual vibration should be avoided to prevent damage to the units. • Clean the units using only a soft, damp cloth to wipe. Do not use solvents, abrasives, detergents or other strong cleaning agents. After cleaning, wipe surfaces with a dry cloth. • Do not submerge units in water or other liquids. • Do not subject the units to extremely severe temperatures - DO NOT PLACE UNITS INTO OVENS, FREEZERS or MICROWAVE OVENS. NOTES • Opening the housing of either the remote sensor or the home receiver other than the battery compartment will invalidate your warranty. Do not attempt to repair this unit. There are no consumer serviceable parts. • If you encounter any difficulties in setting up your wireless thermometer system, please contact Consumer Relations. • Your new RF Thermometer is built with random security code technology. The home receiver will learn the random code of the remote sensors and log it in as channel 1, then set the additional remote sensors as channel 2 and channel 3 if necessary. The home receiver can monitor up to 3 separate sensors. 5