HoMedics UHE-CM15 Downloadable Instruction Book - Page 6

Troubleshooting PROBLEM POSSIBLE CAUSE Power Light is off • Unit is not plugged in • No power at outlet Peculiar Odor Excessive Noise • If new unit • If unit is in use, the odor may be a dirty water reservoir, old tank water or an old wick • Unit is not level • Low water level • Wick was not soaked SOLUTION • Plug unit in • Push POWER button to turn the power on • Check circuits, fuses, try a different outlet • Empty any water and clean and refill tank • Replace wick • Place unit on a flat, even surface • Check the water level. Refill the reservoir if the water is low. • Remove wick, soak for 2 minutes and replace wick Note: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. 10 11