Honeywell 17005 Owners Guide - Page 5

Set-Up: Model 17005 • CONNECT THE BATTERY. The programmable controls and real time clock are battery backed. Upon initial set-up, pull the protective film from the battery door so the battery will make contact and function (Fig. 2). This battery allows you to temporarily unplug your air cleaner without losing program settings. Fig. 2 • INSTALL PRE-FILTER BEFORE USE. Locate the pre-filter in the packaging. Refer to the "How to Install and Replace the Filters" section for proper installation. • SET CURRENT TIME. Plug unit in outlet. NOTE: The air cleaner cannot be programmed unless it is plugged into the outlet. Hold SET button down for approximately 3 seconds. The clock icon and word TIME will appear. You may adjust the hours using the up button and adjust the minutes using the down button. After the current time is set, repeatedly press SET button until ( ) disappears. Manual Operation: Model 17005 The default program setting upon initial start-up is Manual Operation. • To go from Automatic Operation to Manual Operation press the PROGRAM button until both PG1 and PG2 disappear. • To change the speeds in Manual Operation mode press the SPEED button to select the desired setting. • The SPEED button will move through HIGH, MED, LOW, and OFF as noted on the display, and will function independent of programmed settings. Pre-set Program Cycle: Model 17005 To run one pre-set program cycle in a 24 hour period (PG1). PG1 Pre-Setting to run Program One P1-ON 4 PM HIGH SPEED P1-OFF 8 AM To activate pre-set PG1, Press the program button once. PG1 will be displayed. Your machine is now programmed to run from 4pm to 8am on HIGH (Fig. 3a, 3b). Fig. 3a Fig. 3b 5