Honeywell 3800G04-USBKITE User Manual - Page 35
Good Read Delay, User-Specified Good Read Delay, Trigger Modes, Manual/Serial Trigger
View all Honeywell 3800G04-USBKITE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Good Read Delay This sets the minimum amount of time before the imager can read another bar code. Default = No Delay. * No Delay Medium Delay (1000 ms) Short Delay (500 ms) Long Delay (1500 ms) User-Specified Good Read Delay If you want to set your own length for the good read delay, scan the bar code below, then set the delay (from 0-30,000 milliseconds) by scanning digits from the inside back cover, then scanning Save. User-Specified Good Read Delay Trigger Modes Manual/Serial Trigger You can activate the imager either by pressing the trigger, or using a serial trigger command (see Trigger Commands on page 11-4). When in manual trigger mode, the imager scans until a bar code is read, or until the trigger is released. When in serial mode, the imager scans until a bar code has been read or until the deactivate command is sent. In serial mode, the imager can also be set to turn itself off after a specified time has elapsed (see Read Time-Out, which follows). * Manual/Serial Trigger 3800g User's Guide 3 - 3