Honeywell 4800PSF151C-0F00E User Guide - Page 20
Connecting the Imager with Keyboard Wedge
View all Honeywell 4800PSF151C-0F00E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Connecting the Imager with Keyboard Wedge Note: See "Imager Models" on page 1-2 to determine which interfaces apply to your imager. An imager can be connected between the keyboard and PC as a "keyboard wedge," plugged into the serial port, or connected to a portable data terminal in wand emulation or non decoded output mode. The following is an example of a keyboard wedge connection: 1. Turn off power to the terminal/computer. 2. Disconnect the keyboard cable from the back of the terminal/computer. 3. Connect the appropriate interface cable to the imager and to the terminal/ computer. 4. Turn the terminal/computer power back on. The imager beeps. 5. Program the imager for a keyboard wedge interface using the Plug and Play barcodes beginning on page 1-8. 6. Verify the imager operation by scanning a barcode from the Sample Symbols in the back of this manual. The imager beeps once. Your imager is factory programmed for a keyboard wedge interface to an IBM PC AT with a USA keyboard. If this is your interface and you do not need to modify the settings, skip to Chapter 3 - Output. 1 - 4