Honeywell 4800PSF151C-0F00E User Guide - Page 22

Connecting the Imager with RS-232 Serial Port Note: See "Imager Models" on page 1-2 to determine which interfaces apply to your imager. 1. Turn off power to the terminal/computer. 2. Connect the appropriate interface cable to the imager. Note: For the imager to work properly, you must have the correct cable for your type of terminal/computer. 3. Plug the serial connector into the serial port on your computer. Tighten the two screws to secure the connector to the port. 4. Plug the power supply into the cable. 5. Once the imager has been fully connected, power up the computer. 6. Program the imager for an RS-232 Serial Port interface using the Plug and Play barcode on page 1-11. Connecting the Imager with RS-232 Wedge Note: See "Imager Models" on page 1-2 to determine which interfaces apply to your imager. Your imager uses True and TTL signal levels to wedge into an RS-232 serial network. Use only serial wedge cables to prevent damage to the imager. Refer to RS-232 Baud Rate on page 2-10 to set the baud rate and communications protocol. 1 - 6