Honeywell CT1500 Owner's Manual - Page 18

Heating-only System 0 Turn on power to the furnace. 0 Pushboth temperaturecontrol leverstogetherat least 5" F [3" C] above room temperature. The heat should comeon.Thefan will startwhen the furnace heats up. 0 Moveboth levers5" F [3"C] below room temperature. The heat should shut off. 0 Operate the entire heating system for at least one complete cycle. IMPORTANT If thermostat fails any test, refer to troubleshooting guide in owner's manual. Heating/Cooling System 0 Turn on power to the furnace and cooling system. 0 Place the system switch lever at HEAT and the fan switch lever at AUTO. 0 Pushbothtemperaturecontrol leverstogetherat least 5'F [3"C] above room temperature. The heat should comeon.Thefan will startwhen the furnace heats up. On the CT1502, the fan will start immediately. 0 Moveboth leverstogether5"F[3"C]belowroom temperature. The heat should shut off. The fan will stop when the furnace cools. IMPORTANT the cooling system if outdoor temperature is below 50°F [lO°C]. Refer to manufacturer's recommendations. 0 Place the system switch lever at COOL and the fan switch lever at AUTO. 0 Push both temperature control levers together at least 5 O F [3" C] below room temperature. The cooling equipment should operate, and the fan will start. Allow for any time delay that may be built into the compressor control circuit. 0 Movebothleverstogether5°F[30C]aboveroom temperature. The cooling equipment should shut off. 0 Place the fan switch at ON. The fan should run continuously with the system switch in any position. 0 Place the system switch at OFF. Move both temperature: levers to various positions. The heating andcooling systems should not operate. 0 Operate the entire system for at least one complete cycle with the system switch at COOL and one complete cycle with the switch at HEAT. IMPORTANT If thermostat fails any test, refer to troubleshooting guide in owner's manual.