Honeywell HE260A1010 Installation Guide - Page 8

HE220, HE260 HUMIDIFIER INSTALLATION KIT TROUBLESHOOTING YOUR HUMIDIFIER (TABLE 2) Problem Water leakage No water to drain. Air leakage Table 2. Troubleshooting Humidifier. What to look for Leaking joints What to do Shut off water. Tighten connections. Brass tubing inserts Saddle valve leaking Electrical Humidistat Verify that brass tubing inserts are used. Verify rubber pad is installed on saddle valve. Verify control circuit wiring. Check all connections. Turn humidistat up and down and listen for contact to click. Transformer Sail switch Verify that outlet has power. Remove sail cover; turn on furnace fan and listen for faint click. Verify that sail can move freely in duct; check sail switch instructions to trim sail, if necessary. Solenoid After verifying other wiring components, turn on furnace fan, turn humidistat up and down, and listen for solenoid to click. Plumbing Verify plumbing connections. Check for kinks. Saddle valve Humidifier Drain tubing Check duct joints Verify that needle pierced water line and then back out needle to open valve. Remove cover and verify that water flows into distribution tray. Verify no obstructions. Seal with duct tape. Home and Building Control Honeywell 1985 Douglas Drive North Golden Valley, MN 55422 Home and Building Control Honeywell Limited-Honeywell Limitée 35 Dynamic Drive Scarborough, Ontario M1V 4Z9 69-1570 G.H. 09-01 Printed in U.S.A. on recycled paper containing at least 10% post-consumer paper fibers. www.honeywell.com/yourhome