Honeywell HZ2206TGT User Guide - Page 3
Be Sure The Heater Is Not In A Position Where It May Be Tripped Over - thermostat
UPC - 092926343354
View all Honeywell HZ2206TGT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
HZ-2200-3200-3220_OM_Rev1.qx 6/8/05 1:19 PM Page 3 ASSEMBLY (HZ-3200 & HZ-3220 SERIES) • Remove the Handle from the box, it may be nested in the styrofoam packing material. • Place the heater on a firm, level floor. • Line up the prongs on the bottom of the handle with the openings on the top of the heater and firmly push down (Fig. 1). The handle is now permanently fastened to the top cover. NOTE: The HZ-2200 Series does not require any assembly. Fig. 1 SET-UP • Place the heater on a firm, level, open surface free from obstructions and at least 3 feet (0.9m) away from any wall or any combustible material. DO NOT use on an unstable surface such as bedding or deep carpeting. BE SURE THE HEATER IS NOT IN A POSITION WHERE IT MAY BE TRIPPED OVER BY CHILDREN OR PETS. HZ-2200 OPERATION • Place the heater on a firm, level, open surface free from obstructions and at least 3 feet (0.9m) away from any wall or any combustible material. DO NOT use on an unstable surface such as bedding or deep carpeting. BE SURE THE HEATER IS NOT IN A POSITION WHERE Fig. 2 IT MAY BE TRIPPED OVER BY CHILDREN OR PETS. • The Tower Surround Heater is designed to disperse heat in either a 360° range or in one direction only. To select the desired heating mode, slide the Direction Control switch, located on the top of the heater, to 360° Heating the position of your choice (Fig. 2): - to the left ( ) for 360° Heating - to the right ( ) for Forward Only Heating (One Direction Heating) Forward Only Heating (One Direction Heating) • With the Power knob in the OFF position, plug the heater into a polarized 120V outlet. DO NOT FORCE THE POLARIZED PLUG INTO THE Fig. 3 OUTLET; it will only fit one way. • Turn the Thermostat control fully clockwise to the HIGH setting. • This heater is equipped with three (3) settings: High, Low and Fan Only. The High setting uses 1500 watts of power and the Low setting uses 750 watts of power. You can select the proper setting to accommodate your comfort level. Because the Low setting does not require as much electricity to operate, it is more energy efficient and may be a better option if you are concerned about the amperage draw on a circuit when the heater is in the High setting. • Turn the heater on using the Child Resistant Switch (Power knob). To operate the switch, push in the two sides of the Power knob while turning it clockwise to the desired position (Fig. 3). The power light will illuminate. The Child Resistant Switch helps to keep the heater from being turned on unintentionally; there is no way to disengage this safety feature. • When the room reaches a comfortable temperature, slowly turn the Thermostat control counterclockwise until the heating element goes off (the power light will remain on). This is the point at which the Thermostat setting equals the room temperature. At this setting, the Thermostat will automatically turn the heater on and off to maintain the selected temperature. • Push down and turn the Power knob to OFF and unplug the heater when you are finished using it.