Honeywell MS9535-5 User Manual - Page 33
Troubleshooting Guide, Symptoms, Possible Causes, Solution - metrologic 3
View all Honeywell MS9535-5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
TROUBLESHOOTING GUIDE The following guide is for reference purposes only. Contact a Metrologic representative at 1-800-ID-Metro or 1-800-436-3876 to preserve the limited warranty terms. Symptoms Possible Causes Solution The scanner has no LEDs, beeper or laser while seated in cradle. No power is being supplied from cradle to scanner. Check the transformer, outlet and power strip. Verify the power cable is plugged into the cradle properly. The scanner has no LEDs, beeper or laser when out of the cradle. The scanner's internal battery is not supplying power to scanner. Place the scanner into the cradle to recharge the battery. The scanner locks up after the first scan. The white LED stays on and the unit razzes twice. Communication has not been established between scanner and cradle. Establish communication between scanner and cradle before scanning a normal bar code. The scanner locks up after scanning a bar code. The white LED stays on and the unit razzes twice. The distance between scanner and cradle is beyond the 10-meter operation range and RangeGate is not activated. Bring the scanner back into the 10-meter communication range from the cradle. The scanner emits 2 beeps with alternately flashing LEDs on power-up. There may be a possible ROM failure. A flash ROM upgrade required. 29