Honeywell T4700 Owner's Manual - Page 5

Programming Thermostat Initial Powerup When the thermostat is first powered up (or after eight hours of continuous power loss), the display blinks for two seconds and then undergoes a self-test - while 00E displays for about 15 seconds. This is followed by the display flashing (1:00 PM); the internal checkout is complete and the thermostat is ready to be programmed. To verify that the thermostat is turning on the baseboard heater, press the (+) key until the setpoint displayed exceeds the room temperature. The (°) symbol is flashing. Feel for warmth in the area close to the heating element; the unit should be starting to generate heat. Press and hold the Prog key to return the thermostat to the Run mode. Factory Set Programming The thermostat defaults to a normal nonprogrammable thermostat at power-up, indicated with Hold appearing in the display. Pressing the Prog key once enters the programming mode. The thermostat is preset with a factory set schedule for 7 days, see Table 1. Table 1. Preset Factory Schedule for 7-days. Event WAKE LEAVE RETURN SLEEP Time 6:00 AM 8:00 AM 6:00 PM 10:00 PM Temperature 70°F (21°C) 61°F (16°C) 70°F (21°C) 61°F (16°C) 5 69-1396-2