Honeywell W8735B Owner's Manual - Page 5
Battery Installation - telephone access module
View all Honeywell W8735B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Battery Installation The Telephone Access Module requires a 9-volt alkaline battery (not included) to provide the power to dial an alert indicating an extended power interruption. (See Power Outage Setting discussion in Configuring Your Telephone Access Module section.) CAUTION Dead or Missing Battery Hazard. Can prevent Telephone Access Module from dialing power outage alert. Check battery annually or before leaving for extended absence. To install or replace the battery: 1. Remove the front cover latch pin (Fig. 2). 2. Grasp the top of the front cover and swing it down (Fig. 3). 3. Connect the battery leads to the battery (Fig. 4). 4. Insert the battery in the slot. 5. Close the cover. 6. Re-insert the front cover latch pin. battery auxiliary input on line momentary flash - ok on steady flash continuously - replace replace M14813 Fig. 2. Removing front cover latch pin. 5 69-1353