Hoover C1660 Manual - Page 6

2-13 J 2-14 2-15 K Remove hose When using cleaning tools, cleaner handle should be in the upright position. Also, turn cleaner OFF before disconnecting and connecting the hose (J). Remove hose end from cleaner base. Attach wand and tools The tools are attached to the hose or the wand in the same manner. Push tool firmly onto hose; twist tool slightly to tighten or loosen connection. Attach second wand or tool to the wand in the same manner. Replacing hose When you are finished cleaning with the tools, use the end of the hose to push the cover (K) down and push hose onto opening. Twist hose end slightly to tighten the connector. Hose must be connected to cleaner base for floor cleaning. Extra reach hose (available at additional cost) The extra reach hose provides easier cleaning of stairs and hard to reach places. Follow the steps below for attaching and detaching hose. 2-16 L M 2-17 How to clean tools To clean the hose, wipe off dirt with a cloth dampened in a mild detergent. Rinse with a damp cloth. Cleaning tools may be washed in warm water with a detergent. Rinse and air dry before using. Slide hose into slots and twist hose to lock it into place. (To detach hose, reverse procedure.) Attach wands or tools to the other end of hose. Turn cleaner OFF before disconnecting and connecting hose. Remove hose end from cleaner base. Align end of extra reach hose with projections (L) with slots (M) on end of attached hose. 6