Hoover FH50005 Manual - Page 5

1. CVlaecaunuemr AASSSSEEMMBBLLYY Carton contents A. Handle B. Cleaner Base C. Midsection D. Dirty Water Tank E. Clean Water Solution Tank F. Screws (4) G. Nuts (4) 1.1 A C Remove all parts from carton and identify each D item shown. Make sure all parts are located before disposing of packing materials. E B F G ASSEMBLY- Base & Midsection Using a Phillips screwdriver 1.2 Stand base in upright position. Push midsection onto base by aligning tabs on the backside of midsection with the pockets on the backside of base. One at a time, place nut into recess located on the back of the left, right and middle back of the base. While holding nut in place, insert screw through front of midsection and tighten. Repeat this process with the remaining two (2) nuts and screws 1.2 UPPER HANDLE • NOTICE • Make sure the power cord is out of the way to avoid pinching. ASSEMBLY- Handle 1.3 Slide upper handle down onto unit. Place nut into recess in back of upper handle. While holding nut in place, insert screw through front of upper handle and tighten. Route cord above upper cord hook and snap into cord clip on upper handle. 1.3 MIDSECTION TABS 5 UPPER CORD HOOK CORD BASE