Hoover ONEPWR Streamline Cordless Hard Floor Wet Dry Vacuum with Boost Mode Pr - Page 2
Battery Disposal, Warning
View all Hoover ONEPWR Streamline Cordless Hard Floor Wet Dry Vacuum with Boost Mode manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
LUBRICATION: The motor is equipped with bearings which contain sufficient lubrication for their lifetime. The addition of lubricant could cause damage. Do not add lubricant to motor bearings. THERMAL PROTECTION A thermal protector has been designed into your cleaner to protect it from overheating. When the thermal protector activates the cleaner will stop running. If this happens proceed as follows: 1. Turn cleaner OFF (and unplug from outlet). 2. Empty dirty water tank. 3. Inspect the nozzle for any obstructions. Clear obstructions if present. 4. When cleaner is de-energized and motor cools for 30 minutes, the thermal protector will deactivate and cleaning may continue. If the thermal protector continues to activate after following the above steps, your cleaner needs servicing. BATTERY DISPOSAL WARNING - RISK OF EXPLOSION OR EXPOSURE TO TOXIC MATERIAL. LITHIUM-ION BATTERIES The battery must be collected, recycled or disposed of in an environmentally sound manner. The EPA certified RBRC Battery Recycling Seal on the lithium-ion (Li-ion) battery indicated Techtronic Industries, a corporate affiliate of Hoover, Inc., is voluntarily participating in an industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC program provides a convenient alternative to placing used Li-ion batteries into the trash or the municipal waste stream, which may be illegal in your area. Please visit www.rbrc.org/ call2recycle/ for information on Li-ion battery recycling and disposal bans/restrictions in your area. Hoover, Inc., involvement in this program is part of our commitment to preserving our environment and conserving our natural resources. PRODUCT SET-UP 1 Place self-clean tray in a storage area for placement of the unit after use. Ensure this is near an outlet to allow the plug-in of the tray for charging. Use tray for the self-cleaning function. "Click" 2 Attach handle onto body of the unit, proper installation will result in a clicking sound. 3 To insert the ONEPWR battery press the button to release the dock. 4 Slide the ONEPWR battery into the dock until it clicks and push the battery forward until it clicks. BATTERY CHARGING 5 To charge your ONEPWR battery while in unit, place the unit directly down onto the selfcleaning tray and ensure the tray is plugged in. *Battery must be charged prior to initial use FILLING THE SOLUTION TANK WARNING: To reduce risk of injury from moving parts, remove the battery before servicing. Do not use cleaner without tank in place. 1 Remove the clean water tank from the back of the unit by pressing down the button and pulling out. 2 Pull back the tab to access fill hole. 3 First fill with warm water to appropriate water line. Secondly, add solution to solution line. NOTE: Flap must be clicked in place for proper performance and to prevent leaking. NOTE: Read the directions on the Hoover Hard Floor solution prior to use. CLEANING FLUID: SEE THE HOOVER SOLUTION GUIDE insert or visit Hoover.com/cleaningsolutions. 4 Close tab and put clean water tank back into the unit. OPERATION CAUTION: To prevent damage to wood floors, follow the flooring manufacturer's cleaning recommendations. If using cleaner on sealed wood floors, inspect floor surface for worn finish, bare wood or separated joints. Do not use to clean sealed wood floors if any of these conditions exist. IMPORTANT: check for worn spots or joint separations before using, as these conditions could lead to damaged flooring when using water to clean floor. CAUTION: Do not clean over floor electrical outlets. CAUTION: Do not use the cleaner to pick up flammable or combustible liquids or chemicals. 1 Recline by placing a foot gently on the floor head of the unit and pull the handle backwards. 2