Hoover ONEPWR Streamline Cordless Hard Floor Wet Dry Vacuum with Boost Mode Pr - Page 3
Caution, Warning
View all Hoover ONEPWR Streamline Cordless Hard Floor Wet Dry Vacuum with Boost Mode manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
2 Press the power button (power symbol) to turn the unit on. 1 Ensure solution tank is filled to the "Self-Clean" line. If your solution is empty or does not reach that line, fill the tank to the fill line with warm water. CLEANING THE BRUSH ROLL & FOOT WARNING: To reduce the risk of injury from moving parts remove the battery before servicing. Do not use cleaner without nozzle in place. LUBRICATION: The motor and brush roll are equipped with bearings which contain sufficient lubrication for their lifetime. The addition of lubricant could cause damage. Do not add lubricant to motor or brush roll. PINCHING CLIPS 3 Engage with + or - button to change modes depending on your cleaning needs. 2 Remove filter from top of dirty water tank, rinse with water and place in the designated area on self-clean tray PINCH SIDES AND PULL 1 Press the clips on the brush roll cover and lift cover to remove. 4 Press the (+) sign located under the power button. When cleaning tough stains and/or big messes, use boost mode for more power and more water. To turn off boost mode, press the (+) sign again. When in standard cleaning mode press the minus sign to enter dry only mode. SELF-CLEANING FUNCTION CAUTION: Water will drip from the brush roll and underside of the product after use and may puddle. To avoid damage to wood and laminate flooring and to avoid potential slip hazard after use (A) do not need the product on wood and laminate surfaces and (B) placed unit on provided storage tray to contain drips. IMPORTANT: Do not use solvent-based cleaning concentrates in your cleaner. Do not use any type of wax in your cleaner. Dry hands and plug cleaner into a properly grounded outlet. 2 Place the unit upright in the self-clean tray. 3 Empty the tank and rinse. 3 Self-clean will run for 90 seconds and automatically switch off when complete. EMPTYING DIRTY WATER TANK 4 Leave tank and lid out to dry before placing back in machine 1 Once self-cleaning is done. Remove dirty water tank. To remove the tank, press down on the release latch on the front of the tank and pull the tank away from the unit. TIP: Use for picking up small liquid spills (one gallon or less, never to exceed 1/8" in depth). When vacuuming liquid, make sure the product does not get submerged or doused in liquid, which could cause shock, product failure, or personal injury. Ensure filter dries for 24 hrs before reinserting into machine for next use. 3 2 Pull the tab up on the outer side of the brush roll and pull up to remove. 3 Rinse the brush roll and brush roll cover in water.