Hoover ONEPWR Wet/Dry Cordless Utility Vacuum Product Manual - Page 6

ASSEMBLY WARNING! Do not use this product if it is not completely assembled or if any parts appear to be missing or damaged. Use of a product that is not properly and completely assembled or with damaged or missing parts could result in serious personal injury. WARNING! Do not attempt to modify this product or create accessories or attachments not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. If any parts are damaged or missing, please call 800-406-2005. OPERATION WARNING! Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING! Always remove battery pack from the product when you are assembling parts, making adjustments, cleaning, or when not in use. Removing battery pack will prevent accidental starting that could cause serious personal injury. WARNING! Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown into your eyes and other possible serious injuries. WARNING! Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. Applications You may use this product for the following purpose: • Light-duty vacuuming of wet or dry surfaces. Installing/Removing the Flexible Hose See Figure 1, page 9 • Align the raised locking tab on the end of the flexible hose with the slot on the vacuum port. Push in and twist counterclockwise to lock. • Insert the tapered end of the flexible hose into accessory. • To disassemble, remove the accessory from the flexible hose. • Rotate the other end of the flexible hose clockwise to unlock and pull away from the vacuum port. Installing/Removing Battery Pack See figure 2, page 9 • Set the On/Off switch to the Off position. • Insert the battery pack into the product as shown. • Make sure the latches on each side of the battery pack snap into place and that battery pack is secured in the product before beginning operation. • Depress the latches to remove battery pack. Charging the Battery Pack See figure 3, page 9 • Charge the battery fully before first use. This will take up to 3 hours. Due to federal regulations, the battery does not come fully charged. • Plug the charger into a power outlet. • Attach the battery pack to the charger by aligning the ribs on the battery pack to the grooves in the charger. Slide the battery pack into the charger. • When charging, the lights on the battery will illuminate to show the state of charge. The light on the charger will flash. • If the light on the charger illuminates red, there is an error with the battery or the charger. Wait 1 hour and try again or call customer service for support. • When charge is complete the lights on the battery will turn off and the light on the charger will be solid. • To remove the battery pack from the charger, press the latches and pull up on the battery pack. Starting/Stopping the Wet/Dry Vac See figure 4, page 9 • To start the wet/dry vac: Press the On/Off switch to the On position. • To stop the wet/dry vac: Press the On/Off switch to the Off position. PG.5