Hoover U5018 Manual - Page 8
Headlight replacement, Secondary and final, filters
View all Hoover U5018 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Secondary and final filters 3-4 3-5 A B Cleaning secondary filter Disconnect cleaner from electrical outlet. The secondary filter (A), located in the bottom of the bag compartment, protects the motor from dirt particles. If filter becomes dirty, slide filter out. Hand wash filter in cold water with mild detergent, then air dry. Slide dry filter into slot. Should you want to replace this filter, ask for HOOVER part No. 40110004. Cleaning final filter The final filter assists in the filtration process to return clean air to the room. Disconnect cleaner from electrical outlet. To remove this filter when it becomes dirty, remove bag door. Lift out filter (B) and hand wash it in cold water with mild detergent. Let filter air dry and reposition it on the cleaner. Replace bag door. Should you want to replace this filter, ask for HOOVER part No. 40110004. Do not operate cleaner without either the secondary or final filter in place. Headlight replacement 3-8 What to buy This cleaner uses a 13 volt, T-3 114 wedge base bulb, Hoover part No. 27313107. 3-6 3-7 Removing lens Disconnect cleaner from electrical outlet. Press handle release pedal and place handle in low position. Using a Phillips screwdriver, remove the two screws as shown and lift off lens. Installing bulb Pull old bulb straight out of socket. Push new bulb straight into socket until locked in place. Excessive force is not required. Replacing lens Reposition lens and secure with the two screws. 8