Hoover U5458910 Manual - Page 10
Belt replacement, Headlight replacement
View all Hoover U5458910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Headlight replacement What to buy This cleaner uses a 12 volt, wedge base type 912 bulb, Hoover part No. 27313101. 3-7 3-8 3-9 Removing lens Disconnect cleaner from electrical outlet. Using a screwdriver, remove the two screws as shown and lift off lens. Belt replacement The belt on your Hoover cleaner causes the agitator to rotate and is important for the effective operation of the cleaner. The belt is located under the bottom plate of the cleaner and should be checked from time to time to be sure it is in good condition. When to replace Disconnect cleaner from electrical outlet. To check belt, remove bottom plate as shown in "How to replace". Replace belt if it is stretched, cut or broken. What to buy To assure effective operation, use only genuine HOOVER belts with your cleaner. When purchasing a new belt, ask for HOOVER part No. 38528033 (belt package no. 40201160). Installing bulb Pull old bulb straight out of socket. Push new bulb straight into socket until locked in place. Excessive force is not required. 3-10 A How to replace Disconnect cleaner from electrical outlet. Removing bottom plate Place handle in low position and turn cleaner over so bottom side is up. Remove the 4 screws as shown with a Phillips screw driver. Lift off bottom plate (A). 3-12 B B 3-13 C D Installing new belt With lettering on outside of belt and positioned as shown in box on (D), slide new belt over motor pulley (B). 10 E D Replacing agitator brush roll Insert agitator through belt and place belt in belt guide (C) on agitator. Should the agitator shield (D) become dislodged while replacing the belt or the agitator, reposition it as shown noting the placement of its belt guide (E). Replacing lens Reposition lens and secure with the two screws. 3-11 Removing belt Remove agitator brush roll and used belt. Discard used belt. 3-14 F G Securing agitator Grasp agitator firmly and fit it into position by first sliding end opposite the belt into the rectangular slot (F) on side of cleaner. Pull other side of agitator (G) into place. Turn agitator making sure belt is not pinched between agitator and agitator shield.