Hoover UH70832 Product Manual - Page 19

IMPORTANT Allow filter to dry completely before replacing. Dry filter on edge so air circulates on both sides of filter. This may take up to 24 hours. Replace filter, tab side out. Close lid securely by pushing at (B) until it clicks as shown in Fig. 4.6. Replace dirt cup as described in Fig 4.5. Filter Made With HEPA Media: How to Clean 4.8 With fingers in slots, pull filter frame (A) straight out. Hold filter over a trash receptacle and tap out dirt and debris. Slide back into position on vacuum. What to Buy: Rinsable Filter When used and maintained properly, your Rinsable Filter should not need replacement within the warranty period. If desired, additional filter is available at Hoover.com or call 1-800-944-9200. Ask for Hoover® Part No. 304087001 ! WARNING ! To reduce the risk of personal injury - Unplug before cleaning or servicing. Do not use vacuum without dirt cup or filters in place. IMPORTANT 4.8 DO NOT RINSE OR WASH THE FILTER MADE WITH HEPA MEDIA. A What to Buy: Filter Made With HEPA Media When used and maintained properly, your Filter should not need replacement within the warranty period. If desired, additional filter is available at Hoover. com or call 1-800-944-9200. Ask for Hoover® Part No. 305687001. Carbon Filter : How to Clean (Available on select models only). Your Carbon Filter is located on the underside of the Filter made with HEPA media. IMPORTANT DO NOT RINSE OR WASH the Carbon Filter. What to Buy: Carbon Filter Carbon Filter may need to be replaced more often to maintain optimal odor absorbing effectiveness. Additional filter is available at Hoover.com or call 1-800-944-9200. Ask for Hoover® Part No. 902404001. Cyclonic Filter Assembly: How to Clean ! WARNING ! To reduce the risk of personal injury - Unplug before cleaning or servicing. Do not use vacuum without dirt cup or filters in place. 4.9 A 4.10 Remove dirt cup as described in Fig. 4.3. 4.9 Twist filter assembly (A) counterclockwise. Remove assembly from dirt cup. 4.11 4.10 Dirt and debris can be cleaned from the filter assembly with the Dusting/ Upholstery Tool. 4.12 4.11 Place the filter assembly on the dirt cup, B aligning (3) tabs (A) on filter with (3) slots on dirt C cup (B) and twist it clockwise to secure into posi- tion. 4.12 The Hoover® emblem and center lines on the A dirt cup should align on the front of the dirt cup (C) if assembled correctly. Replace dirt cup as described in Fig. 4.5. Actual model may vary from images shown. 10