Hoover UH73301 Product Manual - Page 16

! WARNING ! To reduce the risk of personal injury, unplug before cleaning or servicing. Maintenance Cleaning the Filters: Rinsable Filters 1. Remove dirt cup by pressing the dirt cup release button. 2. Access the rinsable filters under the dirt cup. 3. To remove, pull up on the tab provided. 4. Rinse under running water until all dirt is out of the filters. 5. Let your filters dry for 24 hours before replacing into vacuum. Tip - Replace filters when heavily discolored. Make sure filters are flush to the bottom of the filter housing. Dirt Cup Release HEPA Filters Hoover® REACT™ products have 2 HEPA filters. Refer to Getting to Know Your Hoover® REACT™ QuickLift™ for location. 1. Locate HEPA filters on each side of the vacuum below the dirt cup. 2. Unscrew the vent cover located on the bottom of the canister to access filters. 3. Remove filters and tap on side of trash can to release excess dirt. Tip - DO NOT RINSE HEPA FILTERS. Replace filters when heavily discolored. Do not use your vacuum without all of the filters in place. Remove Filter Cleaning and Maintaining the Brush Roll: 1. To access the brush roll, unscrew the nozzle guard from the nozzle. 2. Remove brush roll by pulling it up and out from the vacuum belt. 3. Remove any hair or blockages. 4. Replace brush roll and nozzle guard. Clean Brush Roll Tip - Rotate brush roll manually to ensure the belt is properly installed. Vacuum is equipped with an automatic brush roll shutoff in the event of overload or jam. Check for obstructions in the brush roll area and remove any obstructions. When obstructions are cleared, resume cleaning as normal. LUBRICATION: The motor and brush roll are equipped with bearings which contain sufficient lubrication for their lifetime. The addition of lubrication could cause damage. Do not add lubricant to motor or brush roll. 14 ! CAUTION ! To reduce the risk of injury from moving parts, do not use vacuum without dirt cup or dry filters.