Hotpoint HDA3500NBB Installation Instructions - Page 3

Installation Preparation-Enclosure PREPARE DISHWASHER ENCLOSURE P!_V_Vl=;_t _11_[_ To reduce the risk of shock, fire, or injury to persons, the installer must ensure that the dishwasher is completely enclosed at the time of installation. • The dishwasher must be installed no more than 10 feet from sink for proper drainage. • The dishwasher must be fullg enclosed on the top, sides, and back. • The dishwasher must not support ang part of the enclosure. • The rough cabinet opening must have a minimum width and depth of 24" and height of 34-1/2" _+1/4" from the floor to the underside of the countertop. • The back wall should be free of pipes or wires. • Adjacent cabinets should be square and plumb to ensure a good fit. Refer to Figure A • For a corner installation, allow 2" minimum clearance between the dishwasher and the adjacent wall. • Provide at least 27" in front of the dishwasher to allow the dishwasher door to open fully. Refer to Figure B Figure B Countertop Clearances: In a corner installation, provide at least 2" clearance between the dishwasher and the adjacent cabinet, wall, or other appliance. Provide at least 27" of clearance in front of the dishwasher. \ 27" Minimum \ This Wall Area must be Free of Pipes or 54-1/2" _+1/4" Underside of Countertop to Floor l Min. Cabinets Square and Plumb Floor MUST be Even with Room Floor Plumbing and Electric Service Must Enter Shaded Area Figure A • Hake sure the floor is level inside the opening and even with the finished floor of the kitchen. This will facilitate removal of the dishwasher at a later date for service, if needed.