Hotpoint RB790DPWW Owners Manual - Page 33

GEAppliances.com in the warming drawer Food dries out in the warming drawer Oven temperature too hot or too cold Clock and timer do not work Display goes blank Oven door is crooked Possible Causes Liquid in worming drawer. Uncovered foods. Temperature setting too high. Moisture escaping. Oven thermostat needs adjustment, Plug on range is not completely inserted in the electrical outlet, A fuse in your home may be blown or the circuit breaker tripped. Oven controls improperly set. A fuse in your home may be blown or the circuit breaker tripped. The clock is turned off from showing in the display. The door is out of position. Oven makes clicking noise "F--and a number or letter" flash in the display This is the sound of the heating element turning off and on during cooking functions. You hove o function error code. If the function code repeats: Power outage Power outage or surge. Display flashes Power failure. UnabtloegetthedisplayOven control pads were not to show "SF" pressed properly. What To Do • Removeliquid. • Cover food with lid or aluminum foil. • Reducetemperature setting. • Cover food with lid or aluminum foil. • See the Adjust the oven thermostat-Easy to do yourself! section. • Hake sure electrical plug is plugged into o live, properly grounded outlet. • Replacefuse or reset circuit breaker. • See the Using the clock and timer section. • Replace the fuse or reset the circuit breaker. • See the Using the clock and timer section. • Because the oven door is removable, it sometimes gets out of position during installation. To straighten the door, push down on the high corner. • This is normal. • Press the CLEAR/OFF pod. Put the oven back into operation. • Disconnect oil power to the range for at least :30 seconds and then reconnect power. If the function error code repeats, coil for service. On self-cleaning models, if o function error code appears during the self-cleaning cycle, check the oven door latch. The latch may hove been moved, if only slightly, from the locked position. Make sure the latch is moved to the right as for as it will go. Press the CLEAR/OFFpod. Allow the oven to cool for one hour. Put the oven back into operation. Some models will automatically resume their setting once the power is restored. On models with o clock, you must reset the clock. If the oven was in use,you must reset it by pressing the CLEAR/OFF pod, setting the clock and resetting ony cooking function. • Resetthe clock. • The BAKEond BROIL HI/LO pods must be pressed otthe some time and held for 3 seconds.