Hotpoint RGB508PEHWH Installation Instructions - Page 18
Care and cleaning of the range., Burner Caps and Heads
UPC - 084691085188
View all Hotpoint RGB508PEHWH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Consumer Support Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions Care and cleaning of the range. Burner Caps and Heads (on sealed burners only) NOTE: Before removing the burner caps and heads, remember their size and location. Replace them in the same location after cleaning. Replacement Replace burner heads over the electrodes on the cooktop, in the correct locations according to their size. Use a sewing needle or twist-tie to unclog the small hole in the burner head. Burner caps Lift off when cool. Wash burner caps in hot, soapy water and rinse with clean water. You may scour with a plastic scouring pad to remove burned-on food particles. Burner heads For proper ignition, make sure the small hole in the section that fits over the electrode is kept open. A sewing needle or wire twist-tie works well to unclog it. The slits in the burner heads must be kept clean at all times for an even, unhampered flame. Clogged or dirty burner ports or electrodes will not allow the burner to operate properly. Any spill on or around an electrode must be carefully cleaned. Take care to not hit an electrode with anything hard or it could be damaged. You should clean the burner caps and burner heads routinely, especially after bad spillovers, which could clog the openings in the burner heads. Lift off when cool. To remove burned-on food, soak the burner heads in a solution of mild liquid detergent and hot water for 20-30 minutes. For more stubborn stains, use a toothbrush. After cleaning Before putting the burner caps and heads back, shake out excess water and then dry them thoroughly by setting in a warm oven for 30 minutes. NOTE: Do not use steel wool or scouring powders to clean the burners. Medium head Small head Front of range Medium head Large head Make sure the slot in the burner head is positioned over the electrode. Replace the matching size caps onto the heads. There is one small, two medium and one large cap. Sizes are stamped into the bottom of the caps. Medium cap Small cap Front of range Medium cap Large cap Make sure that the heads and caps are replaced in the correct locations. NOTE: On some models, the burners are all the same size and power. 18