Hoveround Spitfire EX 4-Wheel Travel Scooter Owners Manual - Page 19

Troubleshooting

Page 19 highlights

Troubleshooting This table is only a guide to aid you in getting your scooter operating, should you have any problems. If you are unable to get your scooter operating, please contact your Authorized Service Center. Table 1: Basic Troubleshooting Symptom Possible Cause Solution Scooter does not move 1. Key switch is not "ON" 2. Main circuit breaker tripped 1. Turn key switch to "ON". 2. Reset circuit breaker in trunk area. 3. Brake release lever in 'Freewheel 3. Place lever to 'Drive Mode'. Mode' 4. Charger connected to outlet 4. Disconnect charger. 5. Battery power low 5. Recharge battery. 6. Scooter shuts down to conserve 6. Cycle key switch "OFF", then "ON". battery 7. Controller error 7. Check diagnostic light for Flash Code (See Table 2 to get solution). Scooter feels 1. Seat is loose wobbly when driven 1. Check seat for loose hardware or damage. Ensure seat in locked position. 2. Bearing in tiller worn 2. Replace bearings. Range less than 1. Charging too infrequently expected 2. Defective or worn out battery 1. Charge scooter more often. 2. Load test batteries. If necessary, replace. 3. Cold weather reduces battery life 3. Allow batteries to reach room temperature and then fully recharge. 4. Defective charger 4. Contact your Authorized Service Center. Erratic behavior 1. Faulty engager when engager is operated 1. Contact your Authorized Service Center. Brake squeals 1. Dirt in brake pad 1. Blow dirt out with air pressure hose. Brake release lever sticks Stiffness in steering 1. Rust and corrosion 1. Possible grime build-up 1. Spray ball detent area with lubrication oil. 1. Lubrication rod end joints. The diagnostic flash codes for your scooter are designed to help you perform basic troubleshooting quickly and easily. A diagnostic flash code flashes from the diagnostic light in the event one of the conditions listed below develops. Spitfire EX 1320/1420 Owner's Manual 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

Troubleshooting
This table is only a guide to aid you in getting your scooter operating, should you have any
problems. If you are unable to get your scooter operating, please contact your Authorized
Service Center.
Table 1: Basic Troubleshooting
Symptom
Possible Cause
Solution
1.
Key switch is not “ON”
1.
Turn key switch to “ON”.
2.
Main circuit breaker tripped
2.
Reset circuit breaker in trunk area.
3.
Brake release lever in ‘Freewheel
Mode’
3.
Place lever to ‘Drive Mode’.
4.
Charger connected to outlet
4.
Disconnect charger.
5.
Battery power low
5.
Recharge battery.
6.
Scooter shuts down to conserve
battery
6.
Cycle key switch “OFF”, then “ON”.
Scooter does
not move
7.
Controller error
7.
Check diagnostic light for Flash
Code (See Table 2 to get solution).
1.
Seat is loose
1.
Check seat for loose hardware or
damage. Ensure seat in locked
position.
Scooter
feels
wobbly
when
driven
2.
Bearing in tiller worn
2.
Replace bearings.
1.
Charging too infrequently
1.
Charge scooter more often.
2.
Defective or worn out battery
2.
Load test batteries. If necessary,
replace.
3.
Cold weather reduces battery life
3.
Allow batteries to reach room
temperature and then fully recharge.
Range less than
expected
4.
Defective charger
4.
Contact your Authorized Service
Center.
Erratic behavior
when engager
is operated
1. Faulty engager
1.
Contact your Authorized Service
Center.
Brake squeals
1. Dirt in brake pad
1.
Blow dirt out with air pressure hose.
Brake release
lever sticks
1.
Rust and corrosion
1.
Spray ball detent area with
lubrication oil.
Stiffness in
steering
1.
Possible grime build-up
1.
Lubrication rod end joints.
The diagnostic flash codes for your scooter are designed to help you perform basic
troubleshooting quickly and easily. A diagnostic flash code flashes from the diagnostic light in the
event one of the conditions listed below develops.
Spitfire EX 1320/1420 Owner’s Manual
18