Hoveround Spitfire EX 4-Wheel Travel Scooter Owners Manual - Page 20

Table 2: Scooter Controller Internal Diagnostics

Page 20 highlights

Table 2: Scooter Controller Internal Diagnostics Flash code 1 2 3 4 5 6 7 8 9 Possible Cause The battery needs charging or there is a bad connection to the battery. There is a bad connection to the motor. The motor has a short circuit to a battery connection. Not available Not available The controller is being inhibited from driving. A speed control lever fault is indication. A controller fault is indicated. The parking brake has a bad connection. Solution Check the connections to the battery. If the connections are good, try charging the battery. Check all connections between the motor and the controller. Please contact your Authorized Service Center. Check the battery charger connector. Remove the battery charger from the scooter. Make sure that the speed control lever is in the rest position before switching on the scooter. Make sure that all connections are secure. Check the parking brake and motor connections. Make sure the controller connections are secure. Excessive voltage has been 10 applied to the controller. Check the battery connections. This is usually caused by a poor battery connection. 19 Spitfire EX 1320/1420 Owner's Manual

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

19
Spitfire EX 1320/1420 Owner’s Manual
Table 2: Scooter Controller Internal Diagnostics
Flash
code
Possible Cause
Solution
1
The battery needs charging or
there is a bad connection to the
battery.
Check the connections to the
battery. If the connections are
good, try charging the battery.
2
There is a bad connection to the
motor.
Check all connections between
the motor and the controller.
3
The motor has a short circuit to a
battery connection.
Please contact your Authorized
Service Center.
4
Not available
5
Not available
6
The controller is being inhibited
from driving.
Check the battery charger
connector.
Remove the battery charger from
the scooter.
7
A speed control lever fault is
indication.
Make sure that the speed control
lever is in the rest position before
switching on the scooter.
8
A controller fault is indicated.
Make sure that all connections
are secure.
9
The parking brake has a bad
connection.
Check the parking brake and
motor connections. Make sure the
controller connections are secure.
10
Excessive voltage has been
applied to the controller.
Check the battery connections.
This is usually caused by a poor
battery connection.