Hunter 20801 Owner's Manual - Page 4
Single Switch Wiring
View all Hunter 20801 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
3 • Assembling and Hanging the Fan Step 3-1 Square Hanger 3-1. Position the square hanger so that the green ground wire attached to the square faces out of the large opening in the metal bracket. 3-2. Holding the wires out of the way, lift the motor assembly and place the square hanger into the opening in the ceiling plate. WARNING: Make sure the square hanger can not rotate in the metal bracket. Failure to do so could result in the fan falling. 3-3. Install two locking screws through the holes in the side of the metal bracket to secure the square hanger. Motor Assembly Step 3-2 Green Ground Wire 6 Green Ground Wire Step 3-3 #8-32 x 1" Screw Locking Screw Hunter Fan Company 42819-01 • 11/14/06 All wiring must be in accordance with national and local electrical codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician. Wall switches are not included. Select an acceptable general-use switch in accordance with national and local electrical codes. 4-1. Make sure the power to the outlet box and associated wall switch location is still OFF. 4-2. To connect the wires, hold the bare metal leads together and place a wire nut over them, then twist the wire nut clockwise until tight. 4-3. Connect the bare or green ground wired (grounded) from the ceiling to the green ground wire (grounded) from the ceiling plate and the green ground wire from the fan. 4-4. Connect the white wire (ungrounded) from the ceiling to the white wired (ungrounded) from the fan. 4-5. Connect the remaining wires as follows: Single Switch Wiring: • The black wire from the ceiling to the black and the black/ white wire from the fan. Dual Switch Wiring: • The black wire from the ceiling to the black wire from the fan. • The black/white wire from the fan to the wire for the wall switch. CAUTION: Be sure no bare wire or wire strands are visible after making connections. 4-6 Turn the splices upward and push them carefully back through the ceiling plate into the outlet box. 4-7 Spread the wires apart, with the grounded wires on one side of the outlet box and the ungrounded wires on the other side of the outlet box. 4 •Wiring the Fan Step 4-3 7 Wire Nut 42819-01 • 11/14/06 Hunter Fan Company