Hunter 23980 Owner's Manual - Page 6
For Standard or Angled Mounting, For Low Profile Mounting
View all Hunter 23980 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
3 • Assembling and Hanging the Fan Steps 3-2 - 3-3 Downrod WARNING: Fan may fall if not assembled as directed in these installation instructions. 3-1. Unbundle the wires from the fan. Canopy For Standard or Angled Mounting: Set Screw 3-2. To assemble fan to hang down from a flat or angled ceiling, insert the downrod through the canopy. Feed the wires from the fan through the downrod. 3-3. Loosen the square head set screw on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the set screw with a wrench or pliers. Skip to Step 3-7. Steps 3-5 - 3-6 Low Profile Washer CAUTION: e adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod. For Low Profile Mounting: 6 Note: For low profile mounting, the downrod is replaced with the low profile washer. 3-4. Remove the set screw from the adapter. 3-5. Place the low profile washer into the canopy. Be sure the green ground wire is pointing up toward the ceiling. 3-6. Align the holes in the washer with the holes in the adapter. Assemble securely with three low profile screws. 3-7. Raise the fan and align the slots in the canopy with the tabs on the ceiling plate. Low Profile Screw Ceiling Plate Tabs Step 3-7 Hunter Fan Company Canopy Slots 42405-01 • 01/20/06