Hunter 25748 Owner's Manual - Page 12

8 • Completing Your Installation With or Without a Multi Staked Light Fixture (Cont.) Steps 8-6 - 8-7 Lower Switch Housing Plug Connector Detail 8-6. To attach the lower switch housing, connect the plug connector from the motor to the plug connector from the receiver in the lower switch housing assembly. Note: Both plug connectors are polarized and will only fit together one way. Make sure the connectors are properly aligned before Plug Connector connecting them. Incorrect connection could cause improper operation and damage to the product. 8-7. Place the lower switch housing assembly over the upper switch housing. Align the side screw holes in the upper and lower switch housings. Attach the lower switch housing to the upper switch housing with three #6-32 x 1/2" housing assembly screws. 8-8. To install each shade, first loosen the three thumbscrews. 8-9. Raise the shade to the light fixture. Tighten the thumbscrews securely. 8-10.Install B10 candelabra base light bulbs (60 Watt maximum each). Note: Glass shade style and number of lights may vary. Housing Assembly Screw Thumbscrews Note: In compliance with US federal energy regulations, this ceiling fan contains a device that restricts the light kit to a maximum of 190 Watts. Exceeding that limit or the marked limit on this product may result in fire hazard or improper operation. Shade Bulb Steps 8-8 - 8-10 12 42419-01 • 11/24/08 • Hunter Fan Company