Hunter 25748 Owner's Manual - Page 5
For Angled Ceilings
View all Hunter 25748 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
2 • Installing the Ceiling Plate 2-1. Drill two pilot holes into the wood support structure through the outermost holes in the outlet box. The pilot holes should be 9/64" Ceiling in diameter. Plate 2-2. Your fan comes with two neoprene noise isolators ("Isolators"). Position the isolators between the ceiling plate and ceiling by inserting the raised areas on each isolator into the holes in the ceiling plate. 2-3. Thread the lead wires from the outlet box down through the hole in the middle of the ceiling plate. 2-4. Align the slotted holes in the ceiling plate with the pilot holes you drilled in the wood support structure. For proper alignment use slotted holes directly across from each other. Note: The isolators should be flush against the ceiling. 2-5. Place a flat washer on each of the two 3" screws and pass the screws through the slotted holes in the ceiling plate into the pilot holes you drilled. Tighten the screws into the 9/64" pilot holes; do not use lubricants on the screws. Do not over tighten. Step 2-2 Flat Washer Toward Ceiling Peak Steps 2-3 - 2-5 3" Screw For Angled Ceilings: Be sure to orient the ceiling plate so that the two tabs are pointing toward the ceiling peak. 5 42419-01 • 11/24/08 • Hunter Fan Company