Hunter 44550 Owner's Manual - Page 6
Read This Before Installing Thermostat - thermostat manual owners manual
View all Hunter 44550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Read This Before Installing Thermostat 6-7 IMPORTANT 1Read the entire installation section of this Owner's Manual thoroughly before you begin to install or operate your Hunter Thermostat. REMOVE THE MYLAR LABEL FROM THE LCD DISPLAY WINDOW. represent most central heating, air conditioning, or space heating units in use in the United States. This Hunter Thermostat will NOT control multi-stage heat pumps or 110/220 Volt systems. INSTALLATION 2 All installation is normally performed at your thermostat. ARMCHAIR PROGRAMMING 3You can program your thermostat before installation by inserting the batteries and following the instructions starting on page 16. This can be done while you relax in your favorite chair and is a very good way to familiarize yourself with all the functions of your Hunter Thermostat. Note: At initial power-up this thermostat is programmed at 68°F (20°C) for Heat and 78°F (26°C) for Cool. Any change to the set temperature will be treated as a Permanent Manual Override. See page 25 for more information. Press Auto Program to load the built-in energy saving programs. OPERATION 4 Your Thermostat is designed to operate with most gas, oil, electric or 2-wire hot water heating and air conditioning systems. It will also operate single-stage heat pumps that do not have auxiliary or emergency heat. These have 24-volt or millivolt control systems and COMPRESSOR PROTECTION 5 The thermostat provides a 3.5 minute delay after shutting off the heating or cooling system before it can be restarted. This feature will prevent damage to your compressor caused by rapid cycling. Note that this delay also applies to the heating system control. It does not provide a delay when there are power outages. TEMPERATURE RANGE 6 Your thermostat can be programmed between 40°F and 95°F (4°C and 35°C). However, it will display room temperatures from 32°F to 99°F (0°C and 37°C). "HI" will be displayed if the temperature is higher than 99°F (37°C), and "LO" will be displayed if the temperature is lower than 32°F (0°C). NOTE: The thermostat will automatically change to the Cool mode if the thermostat measures a temperature over 99°F (37°C). "Hi" will be displayed on the LCD, and the Cooling system will turn On. Similarly, the thermostat will automatically change to the Heat mode if the temperature is below 32°F (0°C). "LO" will be displayed on the LCD, and the Heating system will turn On.