Hunter 82020 Owner's Manual - Page 8
Existing Fan
View all Hunter 82020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Existing Construction B1 EXISTING FAN B2 E Remove an existing fan and check to make sure the opening is large enough to accommodate the new motor hous- ing (7 1/4"x 7 3/4"). Move the housing into position above the ceiling. B3 B4 2 1 Route wires through strain relief. B5 Attach existing ducting to duct connector. Tape joints. If ducting does not fit securely, an adapter may need to be purchased. E Screw pre-loaded screws into joist or framing. 8 42947-01 01/12/2007
EXISTING FAN
B1
E
B2
Existing Construction
B3
2
1
B4
Route wires through strain relief
.
Remove an existing fan and check to make sure the open-
ing is large enough to accommodate the new motor hous-
ing (7 1/4”x 7 3/4”).
Move the housing into position above the ceiling.
Attach existing ducting to duct connector. Tape joints.
If ducting does not fit securely,
an adapter may need to be purchased.
E
B5
Screw pre-loaded screws into joist or framing
.
8
42947-01
01/12/2007