Hunter 82022 Owner's Manual - Page 15
Existing Construction - accessible only from below
View all Hunter 82022 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Existing Construction - accessible only from below D11 EXISTING FAN D12 F Remove an existing fan and check to make sure the opening is large enough to accommodate the new motor hous- ing (8"x 8 1/2"). Move the housing into position above the ceiling D13 D14 2 1 Route wires through strain relief. D15 Attach existing ducting to duct connector. Tape joints. If ducting does not fit securely, an adapter may need to be purchased. F Install the housing flush with the sheetrock and secure by tightening the pre-loaded screws into the joist. 42949-01 04/18/2007 15
EXISTING FAN
D11
F
D12
15
Existing Construction – accessible only from below
D13
2
1
D14
Route wires through strain relief
.
Remove an existing fan and check to make sure the open-
ing is large enough to accommodate the new motor hous-
ing (8”x 8 1/2”).
Move the housing into position above the ceiling
Attach existing ducting to duct connector. Tape joints.
If ducting does not fit securely,
an adapter may need to be purchased.
F
D15
Install the housing flush with the sheetrock and secure by
tightening the pre-loaded screws into the joist.
42949-01
04/18/2007