Husqvarna 129DJx Owners Manual - Page 12
Assembling the cutting, equipment, Fitting the trimmer guard and, trimmer head
![]() |
View all Husqvarna 129DJx manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
ASSEMBLY Dismantling: • Loosen the coupling by turning the knob (at least 3 times). Fitting the trimmer guard and trimmer head • Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard onto the fitting on the shaft and secure with the bolt (L). • Push and hold the button (C). While securely holding the engine end, pull the attachment straight out of the B coupling. C C Assembling the cutting equipment WARNING! ! When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury. A A • Fit the drive disc (B) on the output shaft. • Turn the output shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing. • Insert the locking pin (C) in the hole to lock the shaft. • Screw on the trimmer head/plastic blades (H) in the opposite direction to the direction of rotation. H H • To dismantle, follow the instructions in the reverse order. WARNING! Never use a cutting ! attachment without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury. 12 - English
![](/manual_guide/products/husqvarna-129djx-owners-manual-6b65d8f/12.png)