Husqvarna 129DJx Owners Manual - Page 13
Fitting a blade guard, grass blade, and grass cutter
![]() |
View all Husqvarna 129DJx manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ASSEMBLY Fitting a blade guard, grass blade and grass cutter G F E D A B C • Hook the blade guard/combination guard (A) onto the fitting on the shaft and secure with the bolt. CAUTION! Use the recommended blade guard. See the Technical data section. • Fit the drive disc (B) on the output shaft. • Turn the output shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing. • Insert the locking pin (C) in the hole to lock the shaft. • Place the blade (D), support cup (E) and support flange (F) on the output shaft. • Fit the nut (G). The nut must be tightened to a torque of 35-50 Nm (26-36 ft-lb). Use the spanner in the tool kit. Hold the shaft of the spanner as close to the blade guard as possible. To tighten the nut, turn the spanner in the opposite direction to the direction of rotation (Caution! left-hand thread). English - 13
![](/manual_guide/products/husqvarna-129djx-owners-manual-6b65d8f/13.png)