Husqvarna 525ECS Operation Manual - Page 21
Angle gear, Adjusting the edger's cutting, depth
View all Husqvarna 525ECS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Angle gear MAINTENANCE The angle gear is filled with a sufficient quantity of grease at the factory. However, before using the machine you should check that the angle gear is filled to 3/4 with grease. Use HUSQVARNA special grease. The grease in the bevel gear does not normally need to be changed except if repairs are carried out. Adjusting the edger's cutting depth The cutting depth must be adjusted before starting work. • Loosen the wing nut. • Set the desired cutting depth. • Tighten the wing nut. CAUTION! Use only HUSQVARNA replacement parts. Use of other brands of replacement parts can cause damage to your unit or injury to the operator or others. Your warranty does not cover damage or liability caused by the use of accessories and/or attachments not specifically recommended by HUSQVARNA. 1157435-49 Rev. 3 2016-11-09 English - 21