Husqvarna 525ECS Operation Manual - Page 3

CONTENTS Contents KEY TO SYMBOLS Symbols 2 CONTENTS Contents 3 Note the following before starting 3 INTRODUCTION Dear customer 4 WHAT IS WHAT? What is what 5 GENERAL SAFETY PRECAUTIONS Important 6 Personal protective equipment 6 Machine′s safety equipment 7 ASSEMBLY Fitting the loop handle 11 Assembling the angle gear 11 Assembling the cutting equipment 11 Assembling the blade 11 FUEL HANDLING Fuel safety 12 Fuel 12 Fueling 13 STARTING AND STOPPING Check before starting 14 Starting and stopping 14 WORKING TECHNIQUES General working instructions 16 Basic working techniques 17 MAINTENANCE Carburetor 19 Muffler 19 Cooling system 19 Spark plug 20 Air filter 20 Angle gear 21 Adjusting the edger's cutting depth 21 Maintenance schedule 22 TECHNICAL DATA Technical data 23 FEDERAL AND CALIFORNIA EMISSIONS CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS 24 Note the following before starting: Please read the operator's manual carefully. Maintenance, replacement, or repair of the emission control devices and system may be performed by any nonroad engine repair establishment or individual. WARNING! Long-term exposure to noise ! can result in permanent hearing impairment. So always use approved hearing protection. WARNING! Under no circumstances may ! the design of the machine be modified without the permission of the manufacturer. Always use genuine accessories. Non-authorized modifications and/or accessories can result in serious personal injury or the death of the operator or others. Your warranty may not cover damage or liability caused by the use of nonauthorized accessories or replacement parts. WARNING! An edger can be a dangerous ! tool if used incorrectly or carelessly, and can cause serious or fatal injury to the operator or others. It is extremely important that you read and understand the contents of this operator's manual. The Emissions Compliance Period referred to on the Emission Compliance label indicates the number of operating hours for which the engine has been shown to meet Federal and California emissions requirements. 1157435-49 Rev. 3 2016-11-09 English - 3