Husqvarna 536LiLX Operation Manual - Page 11
Cutting equipment - lowes
View all Husqvarna 536LiLX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
GENERAL SAFETY PRECAUTIONS • the machine is overloaded due to heavy trimming. Release the power trigger and the machine is active. If the warning symbol (3) flashes, it indicates that the machine is too hot and the machine deactivates. When the machine is restored to normal temperature it is again ready to run and you can activate the machine. Solid red warning light (3) indicates service. Power trigger lockout The power trigger lockout is designed to prevent accidental operation of the power trigger. When you press the lock (1) (i.e. when you grasp the handle) it releases the power trigger (2). When you release the handle the power trigger and the power trigger lockout both move back to their original positions. This movement is controlled by two independent return springs. 1 Cutting attachment guard Li-ion This guard is intended to prevent loose objects from being thrown towards the operator. The guard also protects the operator from accidental contact with the cutting attachment. Check that the guard is undamaged and not cracked. Replace the guard if it has been exposed to impact or is cracked. Always use the recommended guard for the cutting attachment you are using. See chapter on Technical data. 2 Make sure the power trigger is locked when the power trigger lock is in its original position. WARNING! Never use a cutting ! attachment without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury. Press the power trigger and make sure it returns to its original position when you release it. Check that the power trigger and the power trigger lockout move freely and that the return spring works properly. WARNING! This machine is renowned for ! its low vibration load. Overexposure to vibration can lead to circulatory damage or nerve damage in people who have impaired circulation. Contact your doctor if you experience symptoms of overexposure to vibration. These symptoms include numbness, loss of feeling, tingling, pricking, pain, loss of strength, changes in skin colour or condition. These symptoms normally appear in the fingers, hands or wrists. Cutting equipment Li-ion See instructions under the heading Start. Start the machine and apply full power. Release the power trigger and check that the cutting attachment stops and remain at a standstill. This section describes how to choose and maintain your cutting equipment in order to: • Obtain maximum cutting performance. • Extend the life of cutting equipment. IMPORTANT! Only use cutting attachments with the guards we recommend! See the chapter on Technical data. Refer to the instructions for the cutting attachment to check the correct way to load the line and the correct line diameter. English - 11